Enabling HTTPS inspection on SafeSquid User Interface

From Secure Web Gateway
Revision as of 16:52, 15 November 2019 by en>Santosh.thorat
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Access the SafeSquid interface

Go to Configure Page

Go to configure page.png

Open Real time content security side menu

Go to real time content security.png

Open HTTPS Inspection section

HTTPS Inspection4.png

Enable HTTPS Inspection

Note: In newer versions of SafeSquid which are released after June-2017, setup tab is removed. You will see only three subsections in HTTPS inspection section.

HTTPS Inspection5.png

Open Global part of HTTPS Inspection section and make the Enabled as True.

HTTPS Inspection6.png

HTTPS Inspection7.png

 

HTTPS Inspection8.png

Open Inspection Policies Tab

Make sure all the policies should be Enabled as True.

HTTPS Inspection9.png

 

HTTPS Inspection10.png

 

HTTPS Inspection11.png

 

HTTPS Inspection12.png

 

HTTPS Inspection13.png

Save Configuration

Click on Save Configuration icon situated at bottom left corner.

Save config final.png

When you click on Save config, it will give a prompt for asking the confirmation to store your configuration  into the cloud. 
Select Yes only in below cases:

  • if you want to use this same configuration in other SafeSquid instances.
  • if your total configuration in all sections is completed and validated. 

Otherwise select No and click on submit

Retrieved from "https://docs.safesquid.com/index.php?title=Enabling_HTTPS_inspection_on_SafeSquid_User_Interface&oldid=2094"